[SOLVED] How to remove empty class section?

Suppose you put a class into a diagram and add an operation to it. Then remove that operation. Now there is an empty section that I have not been able to figure out how to get rid of.

How does one do this?

Hi,

You can use the Class's Symbol view to uncheck the "Operation - Show" tick box, as show in the following GIF :



Best regards,
cde.

Edit: I found it. It's just so small I never saw until now.


Thanks for the reply cde. I tried to figure out how to show the symbol view, and I see a page about the symbol view in the documentation/help, but I have not been able to figure out how to open or access the symbol view. What do I do?